Poster Prints “Rebel Without a cause” – Aussie Decor Transfers

0.2mm thick poster printing.

Comes with a water resistant film on the front of the print.

INSTRUCTIONS:

Plan the placement of the poster on your project
Apply PVA glue to the back of the print and directly to your project with a brush or roller.
Place your poster on your project and smooth out any air bubbles using our blue self-adhesive decoupage tool.
Push the air bubbles from the center of the project to the sides using the felt side of our blue self-adhesive decoupage tool, so as not to damage the image.
Your print comes with a protective film, so only the edges and any cuts or penetrations that puncture the film need to be sealed. If you wish to seal the print to achieve the same finish as your furniture, apply a THIN coat of water-based polyurethane sealant or finish before applying any other finish.
DO NOT apply PVA glue to the print surface as you would other decoupage styles.
DO NOT apply irons, heat or water.

Always use a water-based sealer or finish!

& nbsp;